Sheet #654u – I/O Configuration
Version 1.04a User guide ATEQ 6th series Page 3/4
2. INPUTS CONFIGURATION
This menu is used to give a special function to the inputs 7, 8 or 9 on the connector, of the
Inputs/Outputs16 programs relay board, see the sheets "Electrics connectors", 692/1 for the
F610, 692/2 for the F620 and 692/7 for the F670.
The various functions available on inputs are:
¾Program selection,
¾Synchro test.
The different existing special cycles which appear in regard of the validated functions,
examples:
¾Regulator adjust,
¾Infinite fill,
¾Piezo auto zero,
¾ATR learning cycle,
¾Volume compute,
¾Customer Unit Learning,
¾Check Customer Unit Learning,
¾Check test result,
¾Sealed Pass part learn,
¾Sealed Fail part learn.
As well as the special maintenance cycles if that function is validated:
¾Regulator 1 adjust,
¾Regulator 2 adjust,
¾Leak sensor check,
¾Valve Auto-test,
¾Sensor status.
These functions are all the special cycles available in the instrument.
6 additional inputs are available on the "Outputs codes" board. These inputs are the same as
the board shows above, only the program selection is not available.
To Next Page
Loading...
