QSG_G620_423.00_EN_01_2020-02-17
CONFIGURATION menu
Use this menu to configure your ATEQ device.
Allowed program automatic sequencing
Calculate flow measurement at a specific pressure
value, whatever the real test pressure is
Additional levels for specific reworkable parts
Pneumatic or electric output to identify the part
Calculate measured flow in other ATM pressure and
temperature condition (displays the unit with an *)
Access to International System or American or
Custom Units
Available outputs for external automatism
Selection of the language displayed on the screen
Configuration of the pneumatics functions of the device
Auto-zero every ten minutes
Pressure unit by default for the new programs
Allows negative alarm flow level (same for all programs)
Option that allows dump function and valve type (NC or NO)
Option that allows shut off function
Configuration of the different communications between the
device and its environment
Sending result frames to a PC
Configuration of the communication type on the RS232 port
Setup of the built-in clock
Bar code reader configuration
Configuration of the programmable outputs
Configuration of the programmable inputs
Parameters access mode (key or password)
Deactivation of the Start on the instrument front panel.
Programs can only be started from the instrument relay board.
Configuration of the assigned function to the Smart key
Bargraph display configuration
To Next Page
Loading...
