9
Reception quality
The reception quality of the control may be displayed by pressing the key for 5 seconds.
The reception level will appear for
a minute if no key is touched.
To solve this, move towards the Duolix MAX unit’s mobile control. If the problem persists, carry out the
linking procedure again. Refer to paragraph 5.2 «Linking procedure with the unit».
Fit on a flat surface
The control can be placed on any support surface.
For improved stability, fold out the rear support in
order to place the control in the «easel» position
Mounting on the wall
To place the control on a wall, the mounting
support on the rear needs to be detached first:
Then mount the support on the wall with the screw
(not supplied) and the plugs suitable for your wall.
1 - Separate the base from the support 2 - Pull to unclip it
3 - Use the mounting holes to
attach support to the wall.
4 - Place the control against
the support so that it can
be clipped in together.
If the following screen appears, this means
that the control is not receiving the signal.
To Next Page
Loading...