8
After inserting the batteries, press a key.
The flashing message «OFF» is displayed and the symbol appears on the screen.
The «OFF» message indicates that the control is not linked to the Duolix MAX unit. Linking them
enables the control and the Duolix MAX unit to recognise each other and to communicate with each
other (no interference possible with another unit in the vicinity).
CAUTION: There is a risk of explosion if the batteries are replaced with incorrect batteries. Dispose of
used batteries in accordance with the instructions.
5.2. Linking procedure with the Duolix Max unit
Move towards the dual-flow unit with the control.
• If a link between the control and unit is possible, the following message appears for seven to eight
seconds, then disappears.
The linking procedure has been successful.
• If this message does not appear, follow the linking procedure:
1. Switch off the electrical supply to the Duolix MAX unit directly from a switchboard via the
relevant circuit breaker.
2. Wait for at least 20 seconds
3. Re-establish the electrical supply to the Duolix MAX unit via the circuit breaker.
4. Go to within three metres of your Duolix MAX unit with the control.
• In certain exceptional cases (loss of link), carry out the first four stages stated above, then press the
«Mode» key for ten seconds to launch linking.
5.3. Positioning the control
The range of the control may vary depending on the obstacles (walls, floors, etc.). In most cases, the
range is sufficient to position the control at any location in the house.
Recommendations:
• The control must not be exposed to a source of dampness (shower, basin, etc.)
• The maximum recommended ambient temperature around the control should not exceed 40°C
continually.
• To guarantee correct operation, it is not advisable to place or mount the control on a metal support.
OK
!
!
To Next Page
Loading...