3.17 Modifying parameters
Control panel
Function
To modify a number of parameters. Consult the menu flow in section Control programs.
Procedure
Starting from the Main screen (see Main screen menu):
• Press the key ‘Menu’ (F1).
• Press the arrow down key (1) until ‘Modify Params’ is followed by a horizontal arrow.
• Activate the menu by pressing the tabulator key (2).
• Press the arrow down key (1): the first item ‘Fan Mot. St/Day’ and its setting will appear.
• To modify this setting, press the key ‘Mod.’ (F2), the setting will flash. Use the arrow down key or the
arrow up key (1) to change the value. Press the key ‘Prog’ (F1) to program the new setting or the key
‘Canc’ (F3) to cancel the operation.
• The procedure to modify other parameters is similar.
‘Fan Mot. St/Day’
‘Number’ 240
.
‘Menu’ ‘Mod.’
F1 F2 F3
The regulator will not accept new values beyond the limits. Press the key ‘Lim.’ to check the
limitations for the parameter. Consult section Programmable settings for the most important
settings.
Instruction book
2920 1634 04 41
To Next Page
Loading...
