119
Instruction book
9096 3313 00
8 Maintenance
8.1 Preventive maintenance schedule
Control panel
Warning
Warranty - Product Liability
Use only authorised parts. Any damage or malfunction caused by the use of unauthorised parts is not covered by
Warranty or Product Liability.
Service kits
For overhauling or carrying out preventive maintenance, service kits are available (see section
Service kits).
Service contracts
Atlas Copco offers several types of service contracts, relieving you of all preventive maintenance work. Consult
your Atlas Copco Customer Centre.
General
When servicing, replace all removed gaskets, O-rings and washers.
Control panel Eledtronikon Graphic
Before carrying out any maintenance, repair work or adjustments, proceed as
follows:
• Stop the compressor.
• Close the air outlet valve and press the test button on top of the electronic water
drain(s) until the air system between air receiver and outlet valve is fully
depressurized.
• Press the emergency stop button (10).
• Switch off the voltage.
• Depressurise the compressor.
For detailed instructions, see section Problem solving.
The operator must apply all relevant Safety precautions.
To Next Page
Loading...
