Operator’s instructions
4. Control
49
Table: Symbols
4Green indicator lamp for compressor. The lamp illuminates
when the compressor is switched on.
5Red alarm lamp for compressor. High compressor
temperature. Diesel engine is switched off.
6Yellow alarm lamp for compressor. Read the error message on
the VDO instrument.
7Fuel level gauge (volume)
8Red alarm lamp for low hydraulic oil level. Diesel engine is
switched off.
9Red alarm lamp for diesel engine. Diesel engine is switched
off. Read the error message on the VDO instrument.
10 Yellow alarm lamp for the diesel engine. The diesel engine is in
a critical situation. Read the error message on the VDO
instrument.
11 Yellow indicator lamp for preheating the diesel engine. The
lamp illuminates when preheating is activated.
12 Red indicator lamp for clogged compressor filter and engine air
filter. Stop the engine and replace the filter cartridge.
13 Switch: Compressor charging/Positioning. Reconnect to
charge and select the panel from which the boom system shall
be positioned.
14 Manual cold start (optional equipment)
15 Signal Horn
16 Speed selector. 3 positions.
a: variable engine speed
b: 1500 rpm
c: 1200 rpm
17 Engine speed increase. Used when button (16) is in the
position for "variable engine speed"”(a).
18 Emergency stop. Switches off the diesel engine (reset before
restart)
19 Reset button. (Reset before restart!)
20 Ignition key.
Symbol Description Symbol Description
Hour counter
Shows the total number of
hours for the diesel
engine, as well as shift
memory, by holding the
button depressed for 5
seconds.
Fault codes
Fault codes are stored
here until the ignition is
switched off.
To Next Page
Loading...
