Atlas Copco Tensor STB User Manual

System setup
18 (36) 9836 3043 01
This is done by pressing the right button again until the right number is shown on the display.
Mode 3 works exactly the same way as Mode 1.
4. When the right number is displayed, it is stored by pressing the left button again. The selector
is now ready to be used.
The mode will be stored in the selectors memory even after power off.
3.8 Connecting tool with ToolsTalk Service
The docking station is useful when configuring the tool to operate in an infrastructure W-LAN
environment. It is also useful for service operation on the tool software or tool parameters.
:
1. Connect the tool to
the docking
station. For
instructions on
how to connect the
tool, see section
6.1 Docking
station setup.
2. In ToolsTalk
Service, open
Options > Settings.
3. Select Port and
USB device.
4. Click OK.
Figure 20 TTS settings
5. Click the Connect icon
when the tool is
connected to the
Tensor STB docking
station.
The tool stays connected
during the session with
ToolsTalk Service.
Figure 21 Connect icon
6. Open Configuration > IRC-W. Set parameters 106402 Remote IP Address to the IP address of the
Power Focus, and 106403 Remote Port to the port number same as the controller parameter T293
Power Focus IP port, default 6677..

Atlas Copco Tensor STB Specifications

General

Brand	Atlas Copco
Model	Tensor STB
Category	Power Tool
Language	English