To Next PageTo Next Page
Need help?Do you have a question about the Atlas Copco Tensor and is the answer not in the manual?
General| Category | DC Drives |
|---|---|
| Brand | Atlas Copco |
| Name | Tensor |
| Output Power | Varies by model (Consult specific product documentation) |
| Input Voltage | Varies by model (Consult specific product documentation) |
| Output Voltage | Varies by model (Consult specific product documentation) |
| Communication Interfaces | Ethernet, Fieldbus |
| Enclosure Rating | IP20 (typical, may vary by model) |
Basic precautions for using electric products, including grounding, disconnection, and avoiding water.
Step-by-step guide for installing the DS Drive, connecting cables, and powering on.
Details on the purpose of each button on the DS Drive keypad, including Function and AutoSet.
Guide to using AutoSet to recognize joint stiffness and adjust the tool for optimal performance.
Procedure to fine-tune the final torque target using +/- buttons and the ENTER button.
Steps to perform Torque Tuning when the tool is controlled against an external torque reference.
Function to optimize motor performance and minimize losses after service by running the tool.
Function to detect bad rundowns by monitoring angle in the first and second steps.
Using higher speed than Step 1 Speed for long rundown angles and hard joints.
How to set the service interval and date, and activate the service indicator.
Detailed troubleshooting steps for common error codes like Torque LO, Angle HI, Pset invalid.
