What to do if I mistakenly pressed the TURBO button on my atmosphere 101076?
To stop Turbo mode on your Atmosphere Air Cleaner, press the TURBO button once. To disengage the timer, press the TIMER button repeatedly until all the timer lights are off. Alternatively, turn the air purifier off and then on again to restart it in continuous operation mode, with the same fan setting from before.
How to reset the HEPA filter monitor on atmosphere 101076 Air Cleaner?
If the HEPA filter light is still blinking and your Atmosphere Air Cleaner beeps three times every time you press a button after replacing the filter, reset the HEPA filter monitor. Use a ballpoint pen or the end of a paper clip to press and hold the RESET button until it beeps.
General| Brand | atmosphere |
|---|---|
| Model | 101076 |
| Category | Air Cleaner |
| Language | English |
Describes the path air takes through the purifier's filters and discharge.
Highlights key capabilities like particle removal, odour reduction, and energy efficiency.
Details the unit's operating modes, timer, fan speeds, and monitors.
Provides guidance on optimal placement for air purifier effectiveness and airflow.
Steps for preparing filters for operation and removing them from the unit.
Basic steps to connect the air purifier to a power source.
Explains the four available operating modes: Manual, Auto, Timer, and Turbo.
Details the function of each button on the control panel: Timer, Speed, Turbo, Auto, and Power.
Describes the meaning of different icon colours for filter status and alerts.
Guidance on cleaning the pre-filter and its recommended frequency.
Provides estimated lifespans for HEPA and odour filters and when they need replacement.
Instructions for resetting filters and operating the remote control.
Guidance on cleaning the exterior, pre-filter, and particle sensor filter.
To Next Page
