atmosphere 101076 - Replacing the HEPA Filter

16
Replacing the HEPA Filter
1. Turn power off and unplug the air purifi er.
2. Remove the front cover from the air purifi er using the fi nger tabs located
on each side of the air purifi er – near the top (Fig. 32). Steady the air
purifi er by fi rst placing your thumbs on the outside edges of the control
panel. Remove the front cover by gently pulling on the tabs with your
fi ngers. Then, pull off the bottom of the cover.
3. The pre-fi lter attaches to the outside of the HEPA fi lter. Remove the
combined pre- and HEPA fi lters by squeezing both tabs on either side of
the HEPA frame (near the top) until they unlatch (Fig. 33a).
4. Swing the fi lters out and down away from the housing (Fig. 33).
5. Pull the side tabs to remove the Pre-fi lter from the HEPA fi lter (Fig.34).
Discard the old HEPA fi lter.
NOTE: Vacuum off the pre-fi lter before attaching it to a new HEPA fi lter even if the
pre-fi lter monitor light is green.
6. Remove the new HEPA fi lter from the bag (Fig. 35).
Fig. 32
Fig. 35
Fig. 34
Fig. 33
Fig. 33a