OVERVIEW
02
9
SAFETY INSTRUCTIONS
• To reduce the risk of electric shock, the controller has a three-prong grounding plug
on the power cord. Do not cut, remove or bypass the grounding plug.
• Do not use with an extension cord.
• Do not operate with a damaged power cord. A damaged cord should be replaced by a
licensed electrician or an ATMOX representative.
• In the event of a malfunction, immediately stop operation and disconnect power cord.
• Do not install in standing water or location that could be directly splashed by water.
• Do not wire or attach components while controller is plugged in.
• Do not disassemble, repair or modify the product.
• Do not insert fingers or other items into any openings or ports other than designated
jacks.
• Only use approved ATMOX fans, lights and accessories with the ATMOX controller.
WARNING
WARNING
NOTICE
CAUTION
NOTICE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment OFF and ON, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Industry Canada license- exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
The ATMOX Controller 2.0 conforms to unified standard UL 60730-1 and UL 60730-2-9 and
CSA standard E60730-1 and CSA standard E60730-2-9.
WARNING: Cancer and Reproductive Harm – For more information, go to www.P65Warnings.ca.gov
To Next Page
Loading...