4
SAFETY WARNINGS AND GUIDELINES
Safety Warnings and Guidelines
1. Be careful not to damage the glass build plate.
2. Take care to avoid touching hot parts, including heat
blocks, nozzle, extruded filament, and the heated build
plate.
3. Keep the printer and all accessories out of reach of small
children.
4. Do not remove or disconnect the USB cable when printing
from a computer.
5. Do not pull or twist the black cable harness at any time.
6. Do not force or tear anything during unpacking and
setup. This may cause damage to the printer and/or its
accessories.
7. Do not reach inside the printer during operation. Always
allow the printer and extruded filament to cool before
reaching inside.
8. Ensure that the printer is turned o and unplugged from
its power source before making repairs or performing
service.
9. Do not install this device on an unstable surface where it
could fall and cause either personal injury or damage to
the device and/or other equipment.
10. Do not subject the product to extreme force, shock, or
uctuations in temperature or humidity.
11. This device is intended for indoor use only.
12. Do not expose this device to water or moisture of any
kind. Do not place drinks or other containers with moisture
on or near the device. If moisture does get in or on the
device, immediately unplug it from the power outlet and
allow it to fully dry before reapplying power.
13. Do not touch the device, the power cord, or any other
connected cables with wet hands.
14. Use only in a well-ventilated area. Do not use in conned
spaces.
15. Prior to operation, check the unit and power cord for
physical damage. Do not use if physical damage has
occurred.
16. Before plugging the unit into a power outlet, ensure that
the outlet provides the same type and level of power
required by the device.
To Next Page
Loading...
