Atom 3 Series - Initiate Bed Calibration; Clean the Build Plate

9
011 Idle
Position
X 0 0
Y 0 0
Z 337 3
Bed Calibration Extrusion
Macro
Fan 0%
HOMEConsoleMove
STOPControlPrint Setup
Nozzle 1 Hot Bed
200
70
23.3 24.2
1
Clean the Build Plate
To prepare the build plate for printing, use rubbing alcohol and
a soft, lint-free cloth or white paper towel to remove any dust
and oil from the surface of the glass. DO NOT use colored paper
towels or white board cleaners.
3. Click
[ Control ] > [ HOME ] > [ Bed Calibration ]
on the
LCD screen to auto-leveling.
4. After the automatic calibration is completed, the automatic
calibration sensor will be removed
1
2
3
PREPARING TO PRINT