Part 5：Control box description
1.Emergency stop switch：In case of emergencies, the machine will immediately stop working when you press it. When you
need to unlock it, turn the button clockwise to restart the engraver.
2.Power socket: DC 12V power supply.
3.USB interface: control the engraver on the computer with connecting to the computer through a USB cable.
4. Power switch: control the power on and off.
5. TF card slot: here to insert the TF card.
6. Reset switch: When an emergency occurs or the machine is stuck, press the reset button to restart the engraver.
Before use, please make sure that the emergency stop switch is in the up state.
To Next Page
Loading...
