Part 6：Instructions for use of the display
Click Carve to
enter the TF
card file list
Select the file to be
engraved and move
the laser to the position
to be engraved
Laser focusing
method: place fixed-
focus film under the
laser to define the
focal length
Select the passes
you would
engrave/cut, start
engraving/cutting
During the engraving, the
engraving speed and energy
can be adjusted. If there is an
abnormal situation, click the
pause or stop function key
Select the passes
you would
engrave/cut, start
engraving/cutting
Click the position
button to define
the origin of the
laser
Click the frame
button to define
the engraving
range
Click button，
start carving
Finish engraving
LaserGRBL exports
nc format,
Lightburn exports
gc format
Insert TF
card
Press the
power button
to enter the
home page of
the display
To Next Page
Loading...
