In st rum e nts and w a rnin g/ indi c at o r lig h ts
Sw it c h ing o n t im e, d ate, t e mp era t u re di sp lay, a n d
o do meter
The disp lay appears for approximately 30 seconds when you press
the
!SET] button => page 9, fig. 3 with the ignition off .
St a rtin g t h e Aut o -Ch eck se qu e n ce
The Auto -Check system => page 27 constantly monitors certain indi -
vidual functions and components of the vehicle when the ignition is
turned on and when the vehicle is moving.
With the ign ition turned on, you can start the "Auto-Check
sequence" by pressing the
!SET] button. You can perform an Auto -
Check sequence when the vehicle is stat ionary and the ignition is
turned on or when the vehicle is moving slower than 3 mph
(5 km/hl.
The number of keys programmed to the vehic le is also displayed.
The display
L2 3/ 3 indicates that three keys have been programmed .
This allows you to make sure you have received all of the keys when
you purchase a used vehicle.
For example, if you only receive two keys, you should take those
keys to your authorized Audi dealer to have the missing key deacti-
vated so it cannot be used . You should also report the miss ing key
to your insurance company.
Call ing up th e dri v er informatio n
A yellow or red symbol appears in the instrument cluster disp lay,
usually with a driver message . The driver message display disap -
pears after about 5 seconds. The driver message can be displayed
again by briefly pressing the
!SET] button .
Se ttin g th e s p ee d wa rnin g
By pressing the !SET) button br iefly, you can set threshold 1 of the
speed warning while you are driving=>
page 26. By maintaining
pressure on t he
!SET] button, you delete the warning threshold . •
Digital clock with date display
Digit al c lo ck
Fig. 4 Instr ument
cluster: tim e and dat e
The date, time of day, time and date format can be set in the radio
or in the MMI*. You can learn more about this in the MMI manua l or
in the radio user's manual.
[ i ] Tip s
• The digital clock turns on for about 30 seconds when the driver 's
door is opened.
• When the ignition is turned off, the odometer reading and the
digital clock with date display can be switched on for about
30 seconds by pressing the
!SET] button => page 9, fig. 3. •
Fuel gauge
The fuel gauge works only when the ignition is on .
When the needle reaches the reserve mark, the=>
page 34
~
symbo l appears in the instrument cluster disp lay as well as the
message
Please refuel . There are approxi mate ly 2.6 gallons
(10 liters) of fuel left. This message is meant to remind you to
refuel.
The total tank capacity of your vehic le is listed in => page 319. .,,
To Next Page
Loading...
