0 Note
Never run the tank completely dry! An irregular supply of fuel can
cause engine misfiring and fuel could enter into the exhaust
system. The cata lytic converter could then overheat and be
damaged . •
Odometer
The odometer indicates the distance driven.
Fig. 5 Instrument
cluster: odometer
Fig. 6 Instrument
cluster: reset button
The display of distance driven is shown in kilometers "km" or in
"miles".
• USA models - Miles
Cont rols and equip-
ment
Instruments and warning / indicator lights
• Canada models - Kilometers
You can switch from kilometers to miles or vise versa in the radio or
in the
MMI* using the [SETUP I button.
Odometer/trip odometer
The odometer shows the total number of kilometers or miles that
have been driven on the vehicle .
The trip odometer shows the distance driven since it was last reset.
It can be used to measure short distances. The last digit shows
distances of 100 meters or 1/10 of a mile.
The trip odometer can be reset to zero by pressing the reset button
[O.Ol => fig. 6.
Malfunction message
If there is a malfunction somewhere in the instrument cluster,
dEF
wi ll appear in the trip odometer and will stay on . Contact your
authorized Audi dealer to have the problem corrected.
Immobilize r
When the ignition is switched on, the data on the ignition key are
scanned automatically .
If an unauthorized key was used,
SAFE is displayed permanently in
the odometer disp lay field. The vehicle cannot be operated
=> page 37.
[ i ] Tips
• The date, time, and distance cont inue to show for about 30
seconds after the ignition is switched off.
• The odometer turns on for about 30 seconds when the driver's
door is opened .
• The odometer can be turned on for approximate ly 30 seconds
with the ignition off by pressing the [SET ] button=> page 9, fig. 3. •
Vehicle care
I I
irechnical data
To Next Page
Loading...
