EasyManua.ls Logo

Audi Q5 2011 - Page 109

Audi Q5 2011
312 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- The ACC sensor is dirty. The ACC system is
not reacting, or is not reacting correct ly, to
vehicles traveling ahead.
- It is possible that you are driving on a road
with very light traffic
without anyt hing at
the side of the road (e.g. guard rails, traffic
signs, trees). As soon as a vehicle is detected
by the system again, it returns to its control
range and the text message disappears .
The ACC sensor is located in the right front
tr im grille
¢ page 99, fig. 111. If there is a
loss of operation due to heavy contamination,
this area should cleaned to restore proper op -
erat ion.
ACC not available
The text message ACC not available appears,
for example, if the temperature of the brakes
is excessive. Adaptive cruise control is tempo-
rarily not available . A warn ing tone sounds as
a reminder.
ACC not available!
The text message ACC not available! appears
in the event of a malfunction. Adaptive cruise
control is tu rned off . A warning tone sounds
as a reminder. Have the system inspected by a
qualified dealership.
ACC sensor blocked!
The text message ACC sensor blocked! ap-
pears when the ACC system can no longer
guarantee safe detect ion of objects. Adaptive
cruise control is turned off. A warning tone
sounds as a reminde r.
To decide whether it is necessary to switch off
the ACC (ACC sensor blocked!) or if it is only a
tempo rary condition (ACC Functionally limit-
ed), the system will also takes into considera-
tion t he outs ide tempe ratu re and/or the wind-
shield wiper operation.
The ACC sensor is dirty or blocked (e.g. leaves,
snow) .
The sensor shou ld be cleaned to restore prop-
er sensor funct ion
¢ page 99, fig . 111 .
Adapti v e crui se control 107
Parking brake!
The t ext message Parking brake! appears if
emergency braking was man ually initiated
with the Electromechan ical Parking Brake
(EPB). The adaptive cruise control is turned
off . This is accompan ied by a warning tone .
Stabilisat ion program
The t ext message Stabili sation program ap-
pears if the Elect ronic St abilization Program
(ESP) has intervened. I n this case the adaptive
cruise control is automatically turned off. This
is accompanied by a warn ing tone.
Speed
The set speed in mph (Canada km/h) always
appears when saving or changi ng the speed in
adaptive cruise contro l ¢
page 101, How is
the speed stored?
and c::> page 102, Changing
stored speed.
Speed too low
The t ext message Speed too low appears if
the current speed is too low
to set or to hold
the requested speed.
When sett ing a desired speed, it m ust be at
least 20 mph (30 km/h) . At speeds below 12
mph (20 km/h), the cruise contro l is turned
off.
In speeds over 95 mph (15 0 km/h), the sys-
tem remains act ive and resumes t he speed of
95 mp h (150 km/h) if the driver removes the
foot from the accelerator .
Selector lever position!
The t ext message Selector lever position! ap-
pears when t he select or lever is moved to po-
sition
N. In t his position, adaptive cruise con-
trol is not available.

Table of Contents

Related product manuals