Audi Q5 2024 - Collapsible spare tire

808012721BH
Emergency assistance
The vehicle must also be secured to prevent it
from rolling when using the vehicle jack*. Use
suitable objects to block the front and back of
the wheel that is diagonal from the wheel
with the flat tire.
Removing the caps
BY
Fig. 189 Wheel: wheel bolts with caps
»
Slide
the
plastic
clip
from
the
vehicle
tool
kit
onto
the
cap
until
it engages
© fig.
189.
»
Remove
the
cap
with
the
plastic
clip.
Loosening the wheel bolts
Fig. 190 Wheel: loosening the wheel bolts
>
Slide
the
wheel
wrench*
from
the
vehicle
tool
kit
all
the
way
onto
the
wheel
bolt.
»
Turn
the
wheel
bolt
approximately
one
turn
to.
the
left.
To
achieve
the
required
torque,
hold
the
end
of
the
wheel
wrench*.
If
the
wheel
bolt
will
not
loosen,
press
carefully
on
the
wheel
wrench*
with
your
foot.
Hold
onto
the
vehicle
securely
while
doing
this
and
make
sure
your
footing
is
stable.
ZX WARNING
To
reduce
the
risk
of
an
accident,
only
loosen
the
wheel
bolts
gently
one
turn
before
raising
the
vehicle
with
the
vehicle
jack*.
ig the ve
Applies to: vehicles
BFY-0032|
Fig. 192 Sill: positioning the vehicle jack
» Place the vehicle jack from the vehicle tool kit
ona firm surface. Use a flat, stable support if
necessary. On a slippery surface such as tile,
you should use a non-slip pad such as a rubber
mat > A\.
»
Find
the
marking
on
the
sill
that
is
closest
to
the tire that will be changed © fig. 197. Behind
the marking, there is a lifting point on the side
sill for the vehicle jack.
» Turn the handwheel to raise the vehicle jack un-
der the lifting point on the side sill until the
bracket on the jack @ completely covers the
notch on the vehicle.
» Align the vehicle jack so the bracket (® covers
the notch and the base @)is flat on the ground.
The
base
@
must
be
directly
under
the
mount-
ing point @.
305
>
OwnersManuals2.com