58 Op e nin g and clo sing
LED@ starts to blink (after about 10 sec-
onds) . This procedure clears the standard
codes that were set at the factory and
does not need to be repeated again to
program the other buttons.
3 . Briefly press the button on the roof head -
liner that you would like to program.
4 . Wait unti l the LED@ beg ins to blink. Pro-
gramming mode is active for 5 minutes.
5. Move in front of you r veh icle while ho ld-
ing the original remote control for the
system that would like to program to a
button in the roof headliner.
Programming the butto n: Part 2 on th e
bump er
6 . Hold the remote control towards the left
headlight and the radiator grille
¢ fig. 55.
7. Press and hold the remote control until
the turn signals on your vehicle blink. This
may take up to 30 seconds .
8 . If the emergency flashers blink three
times, the programming was successful.
If the emergency flashe rs on ly blink one
time , the S minute time limit fo r the pro-
gramming has ended or the programming
was not successfu l. Repeat the program-
ming from the third step, or try changing
the distance to the bumper.
9 . If the garage door or other system does
not open us ing the buttons in t he roof
headliner even though the programming
was successful, the system may use a roll-
ing code instead of a fixed code .
Rolling
code programming
must be performed
¢ page 58.
The other two buttons in the roof headliner
can be programmed according to the instruc-
tions above . Begin with the third step .
Erasing button programming
The programmed bu t tons cannot be erased
individually . They must all be erased together .
Reprogram the buttons if necessary.
.,. Switch the ignition on.
.,. Press and hold both outer buttons in the
roof headliner until the LED@ starts to
blink (after about 10 seconds).
Reprogrammin g the button s
.,. Switch the ignition on.
.,. To reprogram an individua l button, press
and hold the button until the LED@ starts
to blink slowly (after about 20 seconds) . Re-
lease the button immediately . Programming
mode is act ive for 5 minutes .
.,. Continue with the fifth step .
(D Tips
- The required distance between the hand
transm itter and the Homelink module in
the bumper ¢
fig. 55 depends on the
system that you a re programming.
- Depending on the model of the system,
you may need to release the button on
the remote control during p rogramming
and press it again. Hold each position
you try fo r at leas t 15 seconds before
t rying another posit ion. Keep t he turn
signa ls on your veh icle in view when do -
ing this .
Rolling code programm ing
Applies to vehicles: with garage door opener (Homelink)
Rolling code programming is also needed for
some systems.
Identifying a rolling code
.,. Press and hold the button in the roof head-
liner that was already prog rammed.
.,. Watch t he LED@ ¢
page 57, fig . 54. If the
LED blinks quickly, the systems (such as a
garage door) is equipped with a rolling code.
.,. Program the rolling code as follows:
Activatin g the motor unit in a system
.,. Locate the programming button on the sys-
tem's motor un it . The exact locat ion and
color of the button may vary depending on
the brand of the system .
.,. Press the programming button on the ga-
rage door opener motor unit (this will usual-
ly activate an "indicator" on the motor unit) .
You now have approximately
30 seconds to
program the button in the roof head liner . ..,.
To Next Page
Loading...
