The indica t or lig ht q fig . 30 starts flashing
rapidly fo r 2 seconds and then blinks slowly.
How is the anti-theft alarm system
switched off?
The anti -the ft a larm system is switched off
on ly when you unlock your vehicle. If you do
not open a door with in 30 seconds after you
have unlocked with the remote control, the
vehicle will lock itse lf again automat ically.
When will the anti theft alarm system be
triggered?
When the veh icle is locked, the alarm system
monitors and protects the following parts of
the vehicle:
- engine compartment
- luggage compartment
- doo rs
- ignition
When the system is activated , the alarm will
be tr iggered if one of the doors, the eng ine
compa rtment lid or the front lid are opened .
The anti-theft a larm system will also go off
when the battery is disconnected .
You can a lso trigger the alarm by pressing t he
PANIC button on your remote-control key.
This will a lert other peop le in case of emer-
gency . Press the
PANIC button again to tu rn
off the alarm .
How is the ant i-theft alarm switched off
when triggered?
The alarm system is switched off when you
unlock the vehicle us ing the remote-control
key or when the ignition is sw itche d on . The
a larm will also switch itse lf off when it comes
t o the en d of it s cycle.
Emergency flasher
The emergency f lasher will blink briefly when
the doors, e ngine compartment lid and fron t
lid are properly clos ed .
If the emergency flashers do not blink, check
the doors, e ngine compartment lid and front
lid to make sure t hey are properly closed . If
Opening and clo sin g 35
yo u close a doo r, the eng ine compartment lid
or the fro nt lid with the anti -theft alarm
switched on, the eme rgency flashers will blink
only after yo u have closed the door or lid.
@ Tips
For the a nti-theft alarm system to f unc-
tion properly, make sure all ve hicle do ors
and windows are closed bef ore leaving t he
vehicle.
Power windows
Controls
The driver can opera te all windo ws.
Fig. 31 Driver's door : power window swit ches
The powe r window switches have a two-posi-
tion function :
Opening the windows
.,. Press t he swit ch a nd hold it down unt il t he
window has reached t he desired posi t io n.
.,. Press t he swit ch
briefly t o open t he window
automatically .
... By br iefly press ing/p ullin g the sw itch again,
the downward t ravel of the window can be
stopped in any pos ition
¢ ,& .
Closing the windows
.,. Pull the sw itch and hold it until the window
has reached t he desire d posi t ion .
... Pull the sw itch
briefly to close t he window
automatically.
... By briefly pressing/pull ing the sw itch again,
the upwa rd trave l of t he window can be
stopped in any pos it ion
¢ ,& . .,.
To Next Page
Loading...
