Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
3.1 Event memory: reading out and erasing
Procedure:
– Connect vehicle diagnostic tester ⇒ page 6 .
– Select Diagnosis mode and begin diagnosis.
– Perform vehicle identification.
– Select “Working with Guided Fault Finding” by entering v and
press Apply
.
The control unit is then identified, and the event memory is inter‐
rogated. Observe notes and test conditions.
– Switch to “Control units” tab and call up “Event memory list”
for an overview of all entries stored in event memory.
– Correct relevant faults and erase event memory.
Note
The event memory is erased automatically if the Guided Fault
Finding is closed correctly.
3.2 Service interval display: resetting serv‐
ice
Procedure:
– Connect vehicle diagnostic tester ⇒ page 6 .
– Select Diagnosis mode and begin diagnosis.
– Perform vehicle identification.
– De-select “Working with Guided Fault Finding” by removing
v and press Apply .
– Switch to “Special functions” tab.
– Select service setting to be reset (e.g. “17 — Inspection”).
– Start program by selecting Carry out check .
– Continue to follow instructions on screen.
Note
Please refer to the relevant Maintenance table for information on
which service channel to reset and what data to enter.
3.3 Transport mode: deactivating
Procedure:
– Connect vehicle diagnostic tester ⇒ page 6 .
– Select Diagnosis mode and begin diagnosis.
– Perform vehicle identification.
– De-select “Working with Guided Fault Finding” by removing
v and press Apply .
– Switch to “Special functions” tab and select following program:
♦ 19 - Activating / deactivating transport mode
Audi R8 2015 ➤
Maintenance - Edition 03.2016
12 3. Maintenance
To Next Page
Loading...
