Audi R8 2015 - Brake System: Checking Condition of Brake Hoses, and Checking that Caps Are Fitted on Bleeder Screws

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Type of service: Fluid level specification:
Brake fluid change Fluid level must be between -max- marking and -min- marking according to wear
level of brake pads.
Checking the brake system for leaks is a repair measure and
should be charged separately.
Procedure:
– Evaluate brake fluid level according to markings on brake fluid
reservoir -illustration-.
– Perform the following measures according to the results of the
check:
Fluid level: Evaluation/measure:
Above MAX marking Extract brake fluid.
Below specified level Carry out brake system leak test ⇒ Rep. gr. 47 ; Hydraulic system; Leak test .
Note
When the vehicle is in use, the fluid level drops due to wear and
automatic adjustment of the brake pads.
3.14 Brake system: checking condition of
brake hoses, and checking that caps are
fitted on bleeder screws
Requirements:
• Brake hoses must not touch any components when steering
is on full lock.
• Brake hoses must not be twisted.
Procedure:
– Check that all brake hoses are secured properly; when doing
so, ensure that the conditions listed are met:
– Check all brake hoses for abrasion, porosity, blistering and
cracking.
– Check that brake connections are seated correctly, and check
for corrosion and leaks.
– If faults are found on brake hoses: Repair/renew relevant com‐
ponent.
– Check that caps are fitted and secured on bleeder screws of
all brake calipers.
– Renew any missing caps.
Audi R8 2015 ➤
Maintenance - Edition 03.2016
26 3. Maintenance