Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Insert metal ruler through opening in brake caliper until it
makes contact with brake disc.
– Using scale on metal ruler, read off brake pad wear value -a-
at outer edge of backplate.
– Repeat procedure on opposite side of vehicle.
– If brake pad thickness has reached wear limit (see table of test
values and procedure guidelines ⇒ page 27 ): Renew brake
pads ⇒ Rep. gr. 46 ; Brake system; Removing and installing
brake pads .
– Fit rear wheels ⇒ Rep. gr. 44 ; Tightening wheel bolts .
Note
♦
When removing the test gauge, take care not to move the slid‐
ing ring. This would give an incorrect measurement.
♦
Note where the test gauge makes contact on the rear of the
brake pad and include the thickness of the damper plate in the
calculation if necessary.
♦
In the case of certain wheel combinations, the front wheels
may have to be removed as well.
♦
The scale on the metal ruler must begin directly at the ruler's
edge; otherwise the measurement will be incorrect.
3.16 Brake discs: checking for surface rust
and operating brakes to clean if neces‐
sary
Checking brake discs ⇒ page 28
Operating brakes to clean brake discs ⇒ page 28
3.16.1 Checking brake discs
Procedure:
– Check outside of all brake discs for surface rust.
– If necessary, operate brakes to clean brake discs
⇒ page 28 .
Note
The brake discs can be damaged irreparably if surface rust is not
removed at the specified intervals.
3.16.2 Operating brakes to clean brake discs
Procedure:
– Accelerate vehicle to 40 km/h, then brake gently to 10 km/h
(do this five times).
– Accelerate vehicle to 40 km/h, then brake sharply to a stand‐
still (do this five times).
Audi R8 2015 ➤
Maintenance - Edition 03.2016
28 3. Maintenance
To Next Page
Loading...
