Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Lubricate front lid locks with universal spray oil - G 000 115
A2- at points marked -arrows-.
– Operate moving parts several times so that the lubricant is
able to penetrate.
– Remove surplus lubricant with cloth.
3.31 Windscreen washer system: checking
spray pattern and adjusting if necessary
Checking spray pattern on windscreen ⇒ page 42
Adjusting windscreen washer jets ⇒ page 42
3.31.1 Checking spray pattern on windscreen
The spray pattern must meet the following specifications:
• Evenly distributed, symmetrical spray pattern
• Uniform, precise jets of water
• Jet unit (passenger's side): Water from all washer jets makes
contact within upper third of wiper area -illustration-
• Jet unit (driver's side): Spray pattern symmetrically opposite
that of jet unit on passenger's side
Procedure:
– Operate windscreen washer system and check spray pattern.
– If spray pattern is not as specified, adjust windscreen washer
jets ⇒ page 42 .
3.31.2 Adjusting windscreen washer jets
Special tools and workshop equipment required
♦ Commercially available adjusting tool (e.g. adjusting tool -
T10127- ) or suitable needle
Procedure:
– Use adjusting tool to align washer jets as required according
to specification.
– If the spray pattern still cannot be set as specified, clean ap‐
propriate washer jets ⇒ Rep. gr. 92 ; Windscreen wiper
system; Adjusting washer jets .
3.32 Wiper blades: checking for damage
Step 1 - service position:
– Switch off ignition.
Audi R8 2015 ➤
Maintenance - Edition 03.2016
42 3. Maintenance
To Next Page
Loading...
