Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
3.24 Suspension struts on front and rear axle:
removing locking elements
Note
♦
These vehicles are identified by a coloured tag fixed to the
mirror -arrow-.
♦
It is not necessary to remove the wheels to perform this oper‐
ation.
Suspension struts on front axle: locking elements (version 1)
⇒ page 33
Suspension struts on front axle: locking elements (version 2)
⇒ page 34
Suspension struts on rear axle: locking elements (version 1)
⇒ page 35
Suspension struts on rear axle: locking elements (version 2)
⇒ page 36
3.24.1 Suspension struts on front axle: locking
elements (version 1)
Special tools and workshop equipment required
♦ Hook - T40207- , wrap metal rod with insulating tape to ensure
that it does not have any burrs or sharp edges.
Requirements:
• Vehicle suspension extended
Procedure:
– Push boot downwards.
Audi R8 2015 ➤
Maintenance - Edition 03.2016
3. Maintenance 33
To Next Page
Loading...
