Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove nut -arrow-.
– Carefully pry selector shaft lever -A- off selector shaft.
– Pry out oil seal with extractor tool -T20143/1- .
Installing
• Tightening torque ⇒ page 93 .
Installation is carried out in reverse sequence; note the following:
– Lightly oil outer circumference of new oil seal.
– Pack space between sealing lip and dust lip -arrow- half full
with sealing grease ⇒ Parts catalogue .
– Drive in oil seal onto stop (take care to keep oil seal straight).
• Closed side of seal -arrow- faces outwards.
Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
1. Flange shafts and oil seals - exploded view 101
To Next Page
Loading...
