Audi TT 2007 - Page 54

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove bolt -arrow- and detach flange shaft (right-side) from
gearbox.
– Unscrew bolts -1 ... 3- and remove pendulum support.
– Unplug electrical connector -3- from vehicle level sender (front
left) -G78- .
– Remove bolt -2-.
Note
-Item 1- can be disregarded.
– Press swivel joint (left-side) off wheel bearing housing ⇒ Rep.
Gr. 40 .
– Pull suspension strut outwards slightly and support in this po‐
sition.
Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
50 Rep. Gr.34 - Controls, housing