Audient EVO 4 User Manual

FIRMWARE UPDATE PROCEDURE
To update your rmware, go to the EVO Application menu and select Check
for Updates.
Provided you have an internet connection, the EVO app will now check with
our update service to see if there are any new rmware updates for your
EVO 4.
If you do not have an internet connection to check the rmware, please
contact our support team at support.audient.com who’ll be happy to assist
you.
If a rmware update is available, you’ll be prompted to install it directly
from our update service. This should take no longer than a minute or so. We
recommended that all speakers are switched o before updating.
During the update procedure, the unit will restart multiple times. Once
complete, reboot the EVO 4 by removing the USB cable, waiting a couple of
seconds and reconnecting it.
FIRMWARE UPDATE FIRMWARE UPDATE

Audient EVO 4 Specifications

General

Type	Audio Interface
Number of Preamps	2
Bit Depth	24-bit
Bus Powered	Yes
Direct Monitoring	Yes
Loopback	Yes
Phantom Power	48V
Sample Rate	96 kHz
Inputs	2 x XLR/TRS Combo
Outputs	2 x TRS
Simultaneous I/O	4 in / 4 out
USB	USB-C
Driver	Class Compliant