Audio Technica AT-LP120-USB Software Guide

9
4. Select the Voice tab.
• In the Voice playback area of the window, select your computer’s internal
sound card (not USB Audio CODEC; not Microsoft Sound Mapper).
• In the Voice recording area of the window, select USB Audio CODEC. Click Apply.
NOTE: If the “USB Audio CODEC” option does not appear, check the USB
cable to ensure it is properly connected to the USB port.
3. The following screen will pop up:

Audio Technica AT-LP120-USB Specifications

General

Interface	USB, Analog
Signal-to-Noise Ratio (SNR)	50 dB
AC adapter frequency	50/60 Hz
AC adapter input voltage	115 - 230 V
Power consumption (typical)	11 W

Weight and Dimensions

Weight	10700 g
Product dimensions (WxHxD)	450 x 352 x 157 mm