Audio Technica AT-LP140XP User Manual

4
1
Dust cover
2
Feet
Adjust the level of the product.
3
Pre-amplifier selector switch
If using an amplifier with a PHONO input jack, set this switch to
the PHONO position. If connecting to the AUX jack of an amplifier,
set this switch to the LINE position.
4
Stereo output terminals
Connect the RCA audio cable. Connect it to either the amplifier's
PHONO input jack or its line input jack. The red terminal is the
right channel and the white terminal is the left channel.
5
Ground (earth) terminal
Connect the amplifier's ground (earth) terminal to this terminal
using the RCA audio cable's ground line.
6
USB output
Use this output to connect your turntable to the USB input of your
computer.
7
Power input jack
Connect the AC adapter.
Part names and functions
Front and rear view diagram
2
3 4 5 6 7
2
1

Audio Technica AT-LP140XP Specifications

General

Type	Direct drive DJ turntable
Operation	Manual
Motor type	DC motor
Brake system	Electronic brake
Pitch control	Yes
Wow & flutter	0.2 %
Nominal speeds	33 1/3, 45, 78 RPM
Starting torque	2.2 kg/cm
Motor brush type	Brushless
Number of speeds	3
Pitch control range	-8 - 16 %
Signal-to-Noise Ratio (SNR)	50 dB
Product color	Silver
Platter material	Aluminum
USB port	-
AC input voltage	115 - 230 V
AC input frequency	50 - 60 Hz
Power consumption (typical)	4.3 W
Shape	S-shaped tonearm
Overhang	16 mm
Tonearm type	Statically balanced tonearm
Tracking angle	3 °
Stylus pressure	6.2 g
Anti-skating range	0 - 4 g
Cables included	RCA/GND

Weight and Dimensions

Weight	10000 g