AudioCodes MediaPack MP-124 Installation Manual

Installation Manual 8 Document #: LTRT-59811
MediaPack Series
Regulatory Information
The Regulatory Information can be viewed at http://www.audiocodes.com/downloads.
Related Documentation
Document Name
Product Reference Manual
MP-11x & MP-124 SIP Release Notes
MP-11x & MP-124 SIP User's Manual
CPE Configuration Guide for IP Voice Mail
Notes: Throughout this manual and unless otherwise specified, the following terms
are used:
• Device refers to the MediaPack series gateways
•
.
•
MediaPack refers to the MP-124, MP-118, MP-114, and MP-112 VoIP
devices.
MP-11x refers to MP-118, MP-114, and MP-112 devices.
Note: The MP-11x and MP-124 devices are indoor units and therefore, must be
installed only indoors. However, the MP-124 FXS telephony cables are
outdoor-compliant and therefore, can be routed outdoors (MP-124 part
numbers MP-124/24S/AC/OD and MP-124/24S/DC/OD).
Caution Electrical Shock
Do not open or disassemble this device. The device carries high voltage and
contact with internal components may expose you to electrical shock and
bodily harm.
Warning: The device is supplied as a sealed unit and must only be serviced by
qualified service personnel.
Warning: Disconnect the device from the mains and Telephone Network Voltage
(TNV) before servicing.
Warning: FXO and FXS ports are considered to be TNV-3.

AudioCodes MediaPack MP-124 Specifications

General

Model	MediaPack MP-124
Category	Gateway
Protocols	SIP, H.323, MGCP
Voice Codecs	G.711, G.723.1, G.726, G.729A/B
Fax Support	T.38
Management	SNMP
Security	TLS/SRTP
Power Supply	100-240 VAC, 50/60 Hz
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-25 to 70°C
Humidity	10% to 90%, non-condensing
Analog Ports	24 FXS