HIGH PERFORMANCE STEREO AMPLIFIER
This power amplifier has been designed to provide high quality performance with
a minimum of maintenance. However, it's performance will only be as good as the
care and quality of components with which it is installed. We therefore advise that
you read these instructions very carefully to familiarize yourself with the product and
it's features.
Should you require assistance with the installation or wiring of this unit, please call
our toll-free "HELP" line at 1-800-645-4994 during the days/hours shown.
Monday-Friday
Saturday
8:30am-7:00pmEastern
9:00am-5:00pm Eastern
1-800-645-4994
HELP!
SPECIFICATIONS
-1-
* Due to continuing improvement, Audiovox reserves the right to change features and design without notice.
Maximum Output Power
Stereo Operation: 150 watts x 2
Mono Operation: 300 watts x 1
Output Power @ 1% T.H.D.
Stereo Operation: 100 watts RMS x 2
Mono Operation: 200 watts RMS x 1
Output Impedance: 2 - 8 ohms (stereo)
4 - 8 ohms (mono)
Frequency Response: 10 - 50,000 Hz. ± 1 dB
Channel Separation: 50 dB
Signal / Noise Ratio: 80 dB (A-Weighted)
Input Impedance: low-level 10K ohms
high-level 100 ohms
Input Sensitivity: low-level 200 mv. - 2 v.
high-level 2 - 10 v.
Filter Types: low-pass & high-pass
Filter Slope: 12 dB/octave
Filter Crossover: Low-pass: 30 - 120 Hz. (selectable)
High-pass: 120 - 800 Hz. (selectable)
Bass Boost: +10 dB @ 50 Hz.
Supply Voltage: 12 volts, negative ground
Fuse Rating: 20 amps.
Dimensions (W x H x D): 9" x 2-1/4" x 10-5/8"
230 mm x 57 mm x 270 mm
To Next Page
Loading...
