12
Functions - Home Page 3
Image
Tap the Image icon to view images stored in the unit’s memory.
Logo Select
Tap the Logo Select icon to select a logo stored in the unit’s memory
(not included) to appear on the start up screen.
SWC
Tap the SWC icon to program steering wheel functions into the unit.
• Connect the KEY 1 wire and KEY 2 wire of the unit’s SWC line with the
respective positive (+) SWC key wires in the vehicle.
If the vehicle only has one positive (+) SWC connection, connect only one Key
wire (either 1 or 2) and insulate the other Key wire.
1. Press SWC to start.
2. To erase any existing SWC programming, press reset, and then press OK.
3. Press the function on the screen you wish to program.
4. Press and hold the corresponding button on the steering wheel.
(a red tick icon will appear when successfully programmed)
5. Repeat steps 3 & 4 for every button.
6. Press Save and Exit once every button has been programmed.
NOTE: This unit can be controlled by analogue SWC signals only. If vehicle has a digital SWC system,
a SWC DAC adapter is required for compatibility. If SWC function is not being used, please insulate all
key wires.
To Next Page
Loading...