AUMA ACE C 01.2 Profinet Series - Page 24

DescriptionValuePrm-Text-Def GSD fileDesignation
(process representation)
Bit
Config. error of REMOTE interface active.1Configuration error RE-
MOTE
Config. error REMOTE
6
No signal0
The phase conductors L1, L2 and L3 are connected in
the wrong sequence.
1Incorrect phase sequence
Incorrect phase seq
7
Phase sequence is ok.0
Byte 17:Warnings 1
The warning signals are for information only and do not interrupt or disable an
operation (as opposed to faults).
Table 15: Byte 17: Warnings 1
DescriptionValuePrm-Text-Def GSD fileDesignation
(process representation)
Bit
No signal (reserved)——0
No signal (reserved)——1
No signal (reserved)——2
FQM Fail Safe fault active:
- "FQM FS-Ready" not ready although "FQM FS-Esd-
Active" not active
- "FQM FS-Ready" ready although "FQM FS-Esd-Active"
active
- "FQM-Timeout-Tension" active
- "FQM-Timeout-Limit" active
—
FQM fail safe fault
3
Warning: Limit value for torque warning in direction
CLOSE exceeded.
1Torque Warning CLOSE
Torque wrn CLOSE
4
No signal0
Warning: Limit value for torque warning in direction OPEN
exceeded.
1Torque Warning OPEN
Torque wrn OPEN
5
No signal0
Warning: A SIL fault of the SIL sub-assembly has oc-
curred.
1SIL fault
SIL fault
1)
6
No signal0
Warning: No actuator reaction to operation commands
within the set reaction time.
1Warning no reaction
Wrn no reaction
7
No signal0
The safety function indications via communication interface are for information only and must not be used as part of a safety function.
The digital I/O signals of the SIL module must be used for this purpose.
1)
Byte 18:Warnings 2
Table 16: Byte 18: Warnings 2
DescriptionValuePrm-Text-Def GSD fileDesignation
(process representation)
Bit
Warning: Temperature within actuator controls housing
too high.
1Warning controls temperat-
ure
Wrn controls temp.
0
No signal0
No signal (reserved)——1
No signal (reserved)——2
The external 24 V DC voltage supply of the controls has
exceeded the power supply limits.
124 V DC, external
24 V DC external
3
No signal0
No signal (reserved)——4
Warning: Voltage of RTC button cell too low.1RTC button cell
RTC voltage
5
No signal0
24
Actuator controls
Description of the data interface AC 01.2/ACExC 01.2 Profinet