AUMA ACE C 01.2 Profinet Series - Page 60

ExplanationSetting valueDefaultAc-
cess
ParametersTypeID
RTC battery monitoring0: Function not active
1R
RTC battery test
enum4135PRM
1: Function active
Limit value (at sensor) for trigger-
ing the acceleration alarm
Min = 500 [0.001 g]1000R
Vibration alarm level
U163517PRM
Max = 4000 [0.001 g]
Table 70: Device configuration > Service interface
ExplanationSetting valueDefaultAc-
cess
ParametersTypeID
Data length = 22 bytes
Information for actuator identific-
ation within the plant (e.g. KKS
designation - Power Plant Clas-
sification system)
_DEVICE-
TAG_
R/W
Device tag
S201165PRM
Settings for service operation
mode. Allows actuator control
via remote operation of service
interface depending on opera-
tion modes LOCAL or REMOTE.
0: Control: LOCAL
0R/W
Service op. mode
enum2175PRM
1: Control: LOC+REM
Table 71: Device configuration > Service functions
ExplanationSetting valueDefaultAccessParametersTypeID
Data length = 4 bytes
Creates new factory settings by
adopting the current settings
Min = 32768-1R
Create factory settings
I163486PRM
Max = 32767
Reset current settings to factory
settings
Min = 32768-1R/W
Reset factory settings
I163487PRM
Max = 32767
Table 72: General information
ExplanationSetting valueDefaultAccessParametersTypeID
Data length = 48 bytes
Torque fault OPEN active
Min = 0R
Torque fault OPEN
BOOL268PZD
Max = 1
Torque fault CLOSE active
Min = 0R
Torque fault CLOSE
BOOL269PZD
Max = 1
Selector switch1: Local
R
Selector switch
enum112PZD
2: Off
3: Remote
Actual position
Min = 0 [0.1 %]R
Actual position
U162PZD
Max = 1000 [0.1 %]
Torque
Min = 0 [0.1 %]R
Torque
U16545PZD
Max = 1000 [0.1 %]
Operation mode0: Power Off
R
Operation mode
enum120PZD
1: EMCY stop
2: Off
3: Service
4: Local
5: Interlock
6: EMERGENCY
7: Remote
8: Remote II
9: Fieldbus
10: Disabled
60
Actuator controls
Appendix AC 01.2/ACExC 01.2 Profinet