AUMA ACE C 01.2 Profinet Series - Page 64

Table 80: Diagnostic > Profinet > Communication status
ExplanationSetting valueDefaultAc-
cess
ParametersTypeID
Data length = 26 bytes
Channel 1 is currently used to
exchange data (DataEx)
R
Channel 1 DataEx
BOOL657PZD
Activity of fieldbus available on
channel 1
R
Channel 1 activity
BOOL613PZD
Activity of fieldbus available on
channel 1
R
Channel 2 activity
BOOL614PZD
Min. one connection to network
available
0: Global link status
R
Network status
BS161663PZD
IP address assigned
1:IP Address Established
No signals
2: Reserved
Network connection at port 1
available
3: Link Status Port 1
Network connection at port 2
available
4: Link Status Port 2
Initialisation of Profinet module
in progress
0: Setup
R
Module status
enum1664PZD
Network initialisation of Profinet
module in progress
1: Network Init
Devices waiting for I/O connec-
tion to I/O controller
2: Wait Process
Connected I/O controller in
STOP mode or has not yet sent
valid data
3: Idle I/O
Connection to an I/O controller
active and no valid data received
4: Process Active I/O
Configuration data is inconsist-
ent or starting parameters faulty
5: Error
Serious error or unexpected be-
haviour of Profinet module or
Profinet application detected
7: Exception
The fieldbus module is not
available
R
Fieldbus mod. not
avail.
BOOL1365PZD
Table 81: Diagnostic > Profinet > I&M 0
ExplanationSetting valueDefaultAc-
cess
ParametersTypeID
Data length = 74 bytes
Manufacturer ID
R
Vendor ID
U165175PRM
Profinet order number
R
Profinet order no.
S201750PZD
Serial number of controls
R
Serial no. controls
S201762PRM
I&M0 hardware revision
R
I&M0 hardw. revision
U165155PRM
I&M0 software revision
R
I&M0 softw. revision
S205209PRM
Parameter Revision Counter
R
Prm Revision Counter
U164948PRM
I&M0 profile ID
R
I&M0 profile ID
U165178PRM
I&M0 profile specification type
R
I&M0 profile spec.type
U165179PRM
I&M0 version
R
I&M0 version
U165180PRM
I&M0 supported
R
I&M0 supported
U165181PRM
64
Actuator controls
Appendix AC 01.2/ACExC 01.2 Profinet