AUMA ACE C 01.2 Profinet Series - Page 68

ExplanationSetting valueDefaultAccessParametersTypeID
The event filter for Events is
used to define which collective
signals are to be recorded into
the event report. As soon as the
memory is full, the oldest events
are overwritten.
0: ER signals
93223R
Event filter for Events
enum188PRM
1: Warnings
2: Fault
3: Not ready REMOTE
4: ER device status
5: Configuration warning
6: Out of specification
7: Function check
8: Maintenance required
9: Failure
10: Configuration error
11: Hydraulics error
12: Wrong oper. com-
mand
13: Internal error
14: Internal warning
15: Fieldbus status
16: Hydraulics warning
17: Failure (Cfg)
18: Fault (Cfg)
19: Warnings (Cfg)
20: Not ready REMOTE
(Cfg)
21: Config. error RE-
MOTE
22: Collective signal 23
23: SIL status
24: Collective signal 25
25: Collective signal 26
26: Collective signal 27
27: Collective signal 28
28: FOC status
29: ER service 1
30: ER service 2
31: ER service 3
Long-term recording on the SD
card
0: Function not active
0R
Long-term recording
BOOL4846PRM
1 Function active
Table 85: Asset Management > Characteristics
ExplanationSetting valueDefaultAccessParametersTypeID
Data length = 62 bytes
Tag for torque-position charac-
teristic 1
_ REF 1 _R/W
Tag torque-position 1
S203191PRM
Tag for torque-position charac-
teristic 2
_ REF 2 _R/W
Tag torque-position 2
S203192PRM
Tag for torque-position charac-
teristic 3
_ REF 3 _R/W
Tag torque-position 3
S203193PRM
Min = 00R/W
No.TorqueCurvesOpen
S205232PRM
Max = 65535
68
Actuator controls
Appendix AC 01.2/ACExC 01.2 Profinet