AUMA SAR 14.2 - Industrial Ethernet Cable: Connect; Accessories for Electrical Connection; Actuator Controls on Wall Bracket

5.4.4. Industrial Ethernet cable: connect
[1] M12 connector for connecting the Industrial Ethernet cable
[2] M12 port
Cable connection
1. Remove protective cap.
2. Connect M12 connector [1] to M12 port for Ethernet cable [2].
3. Tighten cap nut.
5.5. Accessories for electrical connection
5.5.1. Actuator controls on wall bracket
Design Figure 32: Design principle with wall bracket (example)
[1] Wall bracket
[2a] Motor connection/motor control
[2b] Feedback signals from actuator
[3] Electrical connection of wall bracket (XM)
[4] Electrical connection of actuator (XA)
[5] Electrical connection of actuator controls (XK) - customer plug
36
SA 07.2 – SA 16.2 / SAR 07.2 – SAR 16.2 Control unit: electronic (MWG)
Electrical connection AC 01.2 Non-Intrusive EtherNet/IP