1.3 Symbols
This symbol identies the parts of text in the Manual that must be read with
special attention.
This symbol identies the parts of text in the Manual containing warnings,
information and/or instructions that are particularly relevant with regards
to safety; failure in understanding them may cause hazards for People and/
or property.
1.4 To whom the instructions are addressed
The Instruction Manual for the use and the maintenance of the Radio Remote Control is
addressed to Manufacturers, design engineers, Installers, assemblers, mechanics, electricians,
Users, operators, drivers, workers, people responsible for productive activities, Maintenance
Technicians and to all the people who, in any capacity and for any reason, work with an Autec
Radio Remote Control or with the Machine where it is installed.
The Manual must be read carefully, understood and applied in all its parts by:
- the Owner and/or Person responsible for the Machine and/or for the Autec Radio Remote
Control and/or for their operation;
- the Machine Manufacturer, who decides to equip it with a Radio Remote Control;
- the Radio Remote Control Installer or the Person who assembles it on a Machine, device,
Machinery system, etc., and/or who has the responsibility for that operation;
- the Person responsible for safety in the workplace where the Radio Remote Control is used;
- Users, that is to say, those who actually, and in any capacity, are qualied/authorised/
appointed for the use of a Radio Remote Control, or who work with it;
- Maintenance Technicians;
- those who, in any capacity, work with the Radio Remote Control and/or with the Machine,
system, device and/or Machinery system where an Autec Radio Remote Control is
installed, or that are controlled by an Autec Radio Remote Control.
The instructions concerning the installation and maintenance of the Radio
Remote Control are addressed to qualied Personnel; their implementation
requires qualied professional expertise: none of the operation for which
qualied Personnel is required can be carried out by Persons or companies
that do not have the required specic professional expertise.
10
LIUDTH000_eng-01
Information on the use of instructions
AUTEC - Dynamic+ series
To Next Page
Need help?
General
