AUTEC Dynamic+ Series User Manual

9 Maintenance
9.1 Radio Remote Control maintenance - general directions
The Maintenance Technician must:
- observe and comply with all instructions and warnings provided by the Machine
Manufacturer;
- observe and comply with all instructions and warnings provided by the Installer;
- observe and comply with all instructions and warnings provided by the Person responsible
for the Machine commissioning or making the Machine available for work;
- observe and comply with all instructions and warnings provided in the Radio Remote
Control Manual;
- observe and comply with all applicable Laws, Regulations and Standards, even local.
- operate the Autec Radio Remote Control only in accordance with this Manual and all
of its Parts, and with all Autec warnings and instructions, and with applicable Laws,
Regulations and Standards,even local;
- operate the Machine operated by or through the Autec Radio Remote Control only in
accordance with the Machine Manufacturer’s instructions and warnings, and with applicable
Laws, Regulations and Standards, even local;
- operate the Machine operated by or through the Autec Radio Remote Control only when
he is in a safe condition and can perfectly see the whole Machine's working area;
- immediately inform his supervisors and/or the people in charge for the working place
and/or for the Machine about any possible failure, damage, loosening, anomalous wear,
detachment and/or any other anomaly that may cause malfunction to the Radio Remote
Control and/or to the Machine, or that may cause damage to people and/or property;
- keep the Transmitting Unit secure and out of reach of unauthorized and unquali󰘰ed
Personnel.
ADDITIONAL WARNINGS AND INSTRUCTIONS THAT ARE CONTAINED IN
THE OTHER PARTS OF THIS MANUAL MUST BE FOLLOWED.
All 󰘰ne-tuning, checking and maintenance actions carried out on the Radio Remote Control
shall be veri󰘰ed and recorded by the Person in charge of carrying out maintenance on the
Machine.
Before any maintenance operation, disconnect the Receiving Unit from the
power supply, using the devices and instructions provided by the Machine
Manufacturer and by the Installer.
After each maintenance operation, always make sure that all commands sent
by the Transmitting Unit activate only the corresponding expected operations.
42
LIUDTH000_eng-01
Maintenance
AUTEC - Dynamic+ series

AUTEC Dynamic+ Series Specifications

General

Brand	AUTEC
Model	Dynamic+ Series
Category	Remote Control
Language	English