Signal Meaning
The green LED [B] is o. The Transmitting Unit is o.
The green LED [B] is lit with a
steady light.
The Transmitting and Receiving Unit do not communicate.
The green LED [B] repeats the
sequence: two blinks and a pause.
The working range of the remote control has been
exceeded for more than 20 seconds.
The green LED [B] repeats the
sequence: three blinks and a
pause.
The Receiving Unit does not communicate with the
transmitting Unit. If the Transmitting Unit communicates
with the Receiving Unit, it is possible to send commands.
The green LED [B] blinks fast.
The Transmitting and Receiving Unit communicate. It
is only possible to send commands after pressing the
START pushbutton.
The green LED [B] blinks slowly
(one blink per second).
It is possible to send commands.
Signal Meaning
The red LED [A] is o. The Transmitting Unit works correctly.
The red LED [A] is steady on
during start up.
The STOP pushbutton is pressed or damaged.
Press the "Enabling&Stop" pushbutton halfway (ON - rst
step, see paragraph 8.6).
The red LED [A] blinks twice per
second during start up.
At least one of the commands that were checked at start-
up is enabled or damaged (see Technical Data Sheet).
The red LED [A] blinks three times
per second during start up.
The battery is at.
The red LED [A] is steady on for
two seconds during start up.
The Transmitting Unit does not work correctly.
The red LED [A] blinks slowly (one
blink per second).
The battery has less than 1h run time.
The red LED [A] blinks fast. The battery has a 10min run time.
AUTEC - Air series
Light signals 21
LIULK1ES0_eng-01
To Next Page
Loading...
Need help?
General
