AUTEC LK NEO 10 DF User Manual

8.7.3 Indication of the battery charge level in the LK NEO 10 DF Transmitting Unit
(Model LKN Type DA2FM)
See paragraph 7.2.2 to check the battery charge level in the LK NEO 10 DF Transmitting Unit.
8.7.4 Indication of the battery charge level in the LK NEO 10 and LK NEO 12 Transmitting
Unit (Model LKN Type LA2EM)
Perform the following procedure to check the charge level of the battery in the LK NEO 10
and LK NEO 12 Transmitting Units:
1. switch o󰘯 the Transmitting Unit and unlock the STOP pushbutton,
2. press the "Enabling&Stop" pushbutton halfway (ON - 󰘰rst step, see paragraph 8.6);
3. activate command S1 (check in the Technical Data Sheet which actuator it corresponds
to) and press the START pushbutton until LED 1, LED 2 and LED 3 (indicating battery
level) illuminate:
- 1 LED on: low level
- 2 LEDs on: medium level.
- 3 LEDs on: maximum level.
Run time indication disappears after some seconds.
Commands associated to the actuators that are activated during the procedure
to check the battery charge level are not sent to the Machine.
32
LIULK1ES0_eng-01
General operating instructions
AUTEC - Air series

AUTEC LK NEO 10 DF Specifications

General

Brand	AUTEC
Model	LK NEO 10 DF
Category	Transmitter
Language	English