Autel Robotics EVO 2 - Aircraft Preparation

45
3.3 Aircraft Preparation
3.3.1 Unfolding the Aircraft
 Removing & Reinstalling the Gimbal Holder
Always remove the gimbal holder before powering on the aircraft. Slowly pull out
the attached gimbal holder, as shown below.
After using the aircraft, reinstall the gimbal holder to protect the gimbal from
damage.
 Unfolding the Arms & Propellers
 Always unfold the arms and propellers before powering on the aircraft.
 Unfold the front arms first, and then the rear arms.
IMPORTANT
Power off the aircraft before folding it. Fold in the rear arms and propellers