88
MULTIMETERS
J1708 DATA
SETUP MENU
DOWNLOAD
>ABOUT BVA2100
BVA2100
VERSION PM 7.02
DATE 05/16/2013
COPYRIGHT 1999
AUTO METER PRODUCTS
TEST EQUIPMENT
SYCAMORE, ILLINOIS
(815)-883-8378
ABOUT
By selecting the last item on
the main menu…
Gives the version of the software.
4141
CONFIGURING THE BVA-2100 (Cont.)
--CONFIGURATION--
>REQUIRE VEHICLE
ID NUMBERS? YES
USE +/-
'Y' TO SELECT
--CONFIGURATION--
>REQUIRE TECHNICIAN
NUMBERS? YES
USE +/-
'Y' TO SELECT
--CONFIGURATION--
>REQUIRE VISUAL
CHECKS? YES
USE +/-
'Y' TO SELECT
--CONFIGURATION--
>REQUIRE BATTERY
DATE CODES? NO
USE +/-
'Y' TO SELECT
--CONFIGURATION--
>REQUIRE BATTERY
SERIAL NUMBERS? NO
USE +/-
'Y' TO SELECT.
--CONFIGURATION--
>USE TEST RESULTS:
MARGINAL BATTERY.
USE +/-
'Y' TO SELECT.
To require a battery serial number before
each battery test select YES. The manual
will assume NO. If YES is selected then
before each battery test the tester will
prompt for a 14 digit alpha-numeric
serial number. This serial number will be
printed near the bottom of the printout
along with the warranty code.
The date code has a letter for
the month (A to M) and 01/00
for the day and the year. You
have to increment each of
these to the desired date that
will print out in the standard
00/00 format.
Select MARGINAL BATTERY
to allow the test result to be
MARGINAL BATTERY when
a battery is close to being
bad or select GOOD OR BAD
ONLY to not allow marginal
as a test result.
INSPECT BELT CONDITION – TENSION
INSPECT CABLES AND ALTERNATOR OUTPUT
INSPECT BATTERY FOR DIRT, LEAKS OR CRACKS
INSPECT POSTS AND CONNECTIONS
To require battery date code select
YES. The manual will assume NO.
To require visual checks select YES.
The manual will assume NO.
The visual checks, when
required for a particular test,
will request CHECKS before
continuing such as:
When inputting numbers when required in each test, there will be a set of 0000.
Use the (UP) or (Down) key to select the desired number for the rst zero then
press (ENTER) to advance to the next 2000.
To require vehicle ID numbers select
YES. The manual will assume NO.
To require technician numbers select
YES. The manual will assume NO.
The following may be needed in eet operations. The manual will
assume NO in all cases. If you select YES, you will be asked to input
the information or perform certain checks as requested in each test.
To Next Page
Loading...
Need help?
General
