For more information visit www.auto-trail.co.uk 26
EMPTYING THE WASTE TANK
Your toilet has a 1-level indication for the waste holding tank. When the slide turns from green to red, the
waste-holding tank is full.
• Remove the waste-holding tank (01).
• Fold out the pull handle until it is fully extended (07).
• Pull the tank to an authorised waste disposal point (08).
• Place the waste-holding tank upright and turn the pour out spout upwards.
• Remove the cap from the pour out spout (02).
• Press and hold the vent button with your thumb while the pour out spout is pointing downwards to
empty the waste-holding tank (09).
• Add ±5ltr of water to the waste-holding tank and replace the cap (10).
• Gently shake the tank to clean it (11). Empty the waste-holding tank again (09).
• Remove the float from the waste-holding tank by turning it clockwise and rinse the float with tap water (12).
• Fold in the pull handle until it clicks into place.
• Slide the waste-holding tank into the toilet and close the service door.
• Follow the 'before using the toilet' instructions to prepare it for use again.
Please note: To prevent water damage to your motorhome, do not travel with a waste-holding tank that is
more than 75% full. This may cause leakage through the venting system. Thetford green toilet additives are
completely safe to empty into a septic tank or small biological systems on camping sites.
To Next Page
Loading...
