Autocruise 2012 Van Conversion Range - Care of Laminate Tops, Tables, Furniture and Doors; Furniture Doors; Omnistep Slide-Out Step; Shower

equipment details
124
Care instructions:
- Please clean the acrylic panes with the
SeitzAcrylicCleaner.
- Stains and light scratches on the acrylic
pane can be removed by using the
SeitzAcrylicPolishandtheSeitzspecial
polishing cloth.
- Use talcum powder (4 times yearly) to care
for the rubber seals
- Clean the blinds only with water and mild
soap suds
- The guarantee becomes null and void if
these instructions are not followed.
FURNITURE DOORS
During normal travelling, vehicle vibration
and flexing may cause some of the furniture
doors to become out of alignment. For your
convenience many hinges are adjustable.
TABLE STORAGE
Tables stored in the table storage
compartment must be securely clipped into
place whilst in transit.
To avoid damage care must be taken when
removing tables from their stored position.
CARE OF LAMINATE TOPS,
TABLES, FURNITURE AND DOORS
DONOTuseabrasives,chemicallytreated
cloths or aggressive detergents as these may
cause damage.
DONOTplacehotobjectsonlaminated
surfaces i.e. tops, tables. Any temperatures
70°C and over will cause permanent damage.
Clean worktop surfaces, furniture and door
fascias with a soft, slightly damp cloth, dry off
with a soft cloth.
SHOWER
When using the shower, always ensure that
the shower door is fully closed thus avoiding
water spray on unprotected areas.
OMNISTEP SLIDE-OUT STEP
Operation
Press the “step out” key to bring the step out
until it reaches the end of its run or comes up
against an obstacle. The step does not come
out if the engine is running. Press the “step in”
key to take the step back until it reaches the
end of its run or comes up against an obstacle.
The step goes back in automatically when the
engineisrunning.Inthissituationthebuzzer
sounds until the step is fully closed.
Maintenance
Dirt and frost can prevent the step from
operating properly. In this case the rails and
moving parts should be cleaned or defrosted.
In case of electric break down
If the step does not retract by the motor
- Remove the front plate of the step. (Fig. 1)
- Remove the connection between the
footboard and the arms (with screwdriver
and wrench S10).
- Slide out the footboard.
- Reinstall the front plate.
Current drawn
- Working current: 5 A
- Blocking current, when fully extended or
retracted: 14 A
Fig. 1 Front plate
doors, table storage, care of funiture,
shower & omnistep