Autocruise 2012 Van Conversion Range - Trumatic E2400

equipment details
72
TRUMATIC E2400
Trumatic E 2400 L.P.G. Heater with
electronic control, built-in air distribution
and thermostat
Operating instructions
Always observe the operating instructions and
‘Important operating notes’ prior to starting!
The vehicle owner is responsible for the correct
operation of the appliance!
The installer or vehicle owner must apply the
yellow sticker with the warning information,
which is enclosed with the appliance, to a
place in the vehicle where it is clearly visible
to all users (e.g. on the wardrobe door)! Ask
Truma to send you stickers, if necessary.
Control panel with sliding switch
a Slide valve
Heating–Off–Ventilation
b Slide valve for high setting (large flame
symbol) and low setting (small flame symbol)
Control panel with rotary switch
c ‘Heating’rotaryswitchhighsetting
(large flame symbol) and low setting
(small flame symbol)
d ‘Off’ rotary switch
e ‘Ventilation’ rotary switch high setting
(large symbol) low setting (small symbol)
Switching on the Heating
1. Remove cowl cap.
2. Turn on gas cylinder and open quick-acting
valve in the gas supply line.
3. Adjust desired room temperature at
rotary knob.
4. Switching the heating on:
Control panel with sliding switch:
Settheswitch(a)toHeatingandswitch(b)to
the desired output setting.
Control panel with rotary switch:
Set the rotary switch to the desired output
setting (c). If the outside temperature is low,
switch to high setting.
The Trumatic E heater has been tested and
approved for operation, also when the vehicle
is moving. The burner with fan assistance
guarantees satisfactory operation, even
under extremely windy conditions. It may
be necessary to observe respective, country-
specific regulations for the operation of liquid
gas appliances when the vehicle is moving.
Switching on the Ventilation
Control panel with sliding switch:
Set switch (a) to Ventilation and switch (b) to
the desired output setting.
Control panel with rotary switch:
Set the rotary switch to the desired output
setting (e).
Switching off
Set the sliding switch (a) or the rotary switch
(d) to the centre. If the appliance is switched
off after a heating phase, the fan can continue
running in order to make use of the residual
heat.
trumatic lpg heater