82
Technical data
DeterminedinaccordancewithEN624or
Truma test conditions
Type of gas: Liquid gas (propane / butane)
Operating pressure: 30 mbar (see type plate)
Water contents: 10 litres
Heating up time from approx. 15° C to
approx. 60° C
Boiler approx. 20 minutes (measured according
toEN15033)Heater+boilerapprox.80min.
Water pressure: max. 2.8 bar
Rated thermal output
(automatic output levels)
Combi 4: 2000 / 4000 W
Combi 6: 2000 / 4000 / 6000 W
Gas consumption
Combi 4: 160 – 320 g/h
Combi 6: 160 – 480 g/h
Readiness-heat power requirement Combi 4 /
Combi 6: 5.2 g/h
Air delivery volume (free-blowing without
hot-air pipe)
Combi 4: with 3 hot-air outlets max. 249 m3/h
with 4 hot-air outlets max. 287 m3/h
Combi 6: with 4 hot-air outlets max. 287 m3/h
Current input at 12 V
Heater+boiler
Combi 4: Short-term max. 5.6 A
(average power consumption 1.1 A)
Combi 6: Short-term max. 5.6 A
(average power consumption 1.3 A)
Heatingupofboiler:0.4A
Stand-by: 0.001 A
HeatingelementFrostControl(optional):
maximum 0.4 A
Weight (without water contents): 14.5 kg
Declaration of conformity
The Truma Combi has been tested by the
DVGW and complies with the gas equipment
directive (90/396/EEC) and the other applicable
EC directives. The following CE Product Ident.
No.isavailableforEUcountries
Combi 4 / Combi 6: CE-0085-BS0085.
The heater complies with heater directive
2001/56/EC and supplements 2004/78/EC
and 2006/119/EC and bears the type approval
number Combi 4: e1 00 0193 Combi 6: e1 00
0194.
The heater complies with the interference
suppression directive 72/245/EEC for vehicle
engines with annexes 2004/104/EC, 2005/83/
EC and 2006/28/EC and bears type approval
number: e1 03 5020.
The heater complies with EMC directive 89/336/
EEC and low voltage directive 73/23/EEC.
For troubleshooting a fault please refer to
page 14 of the Truma Combi 4 / Combi 6
Operator Manual.
truma combi 4 /combi 6